SNAPMAKER J1
IDEX Direct DriveAuto-LevelMarlin-based
Specifications
| Build Volume | 300x200x200mm |
|---|---|
| Bed Type | PEI-coated Glass |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | 100°C |
| Hotend Type | All-Metal |
| Cooling | Dual Part Cooling Fans |
| Max Speed | 350 mm/s |
| Max Acceleration | 10000 mm/s² |
| Motion System | corexy |
| Firmware | Marlin-based |
| Nozzle Sizes | 0.2mm · 0.4mm · 0.6mm · 0.8mm |
Known Issues
low
IDEX offset calibration
Independent dual extruders require accurate XY offset calibration between the two hotends to avoid layer shifting on multi-material or mirror/copy mode prints.
Mitigation: Run the built-in electrical-contact offset calibration before each major print session, especially after a nozzle swap.
low
No enclosure
J1 is open-frame, unlike most other Snapmaker models. High-warp materials like ABS/ASA are more prone to warping without ambient temperature control.
Mitigation: Consider a DIY enclosure or draft shield for ABS/ASA. PLA/PETG/TPU work well without one.
Filament Compatibility
Maintenance Tips
Run IDEX offset calibration regularly, especially after nozzle swaps.
Keep both nozzles clean and check for consistent flow between extruders.
Regularly clean the print bed to maintain adhesion quality.
Popular Upgrades
Best For
dual-material and dual-color printinghigh-speed printingmulti-material projects without needing a purge tower
DIALED-IN SETTINGS
FixMyPrint generates exact slicer settings for the Snapmaker J1 - calibrated for your filament and slicer in seconds.
Generate Settings for This Printer