CREALITY CR-10 V2

bowden longMarlin

Buy on Amazon →Affiliate link - helps support FixMyPrint

Specifications

info

The PTFE tube can wear down over time, affecting extrusion quality.

Mitigation: Regularly check and replace the PTFE tube if any wear is observed.

warning

Some users experience issues with prints not sticking to the glass bed.

Mitigation: Use adhesives like glue stick or hairspray to improve bed adhesion.

PLAexcellentPerforms very well with standard settings.

PETGgoodRequires careful tuning for best results.

ABSfairLimited by open frame; enclosure needed for best results.

ASAfairSimilar challenges as ABS with temperature management.

TPUfairPrinting speed should be reduced significantly.

NylonpoorHigh temp and moisture sensitivity can be problematic.

PCpoorRequires high temp and controlled environment.

Regularly lubricate the Z-axis lead screw.

Check and tighten all bolts and belts periodically.

Calibrate the bed level frequently to ensure optimal print quality.

BLTouch for auto bed leveling

Direct drive upgrade for better flexibility with flexible filamentsAmazon →

All-metal hotend for higher temperature printing

Large volume printsPrototypingBeginners looking for a reliable workhorse

FixMyPrint generates exact slicer settings for the Creality CR-10 V2 - calibrated for your filament and slicer in seconds.