ANYCUBIC KOBRA PLUS

Direct DriveAuto-LevelMarlin

Buy on Amazon →Affiliate link - helps support FixMyPrint

Specifications

warning

Issues with first layer adhesion due to glass bed surface.

Mitigation: Use a glue stick or hairspray to improve adhesion.

info

The bowden setup can cause filament feed issues with flexible filaments.

Mitigation: Print at lower speeds and ensure proper tension in the filament extruder.

PLAexcellentPerforms well with default settings.

PETGgoodMay require tuning for optimal results.

ABSfairRequires an enclosure for best results.

ASAfairSimilar to ABS; enclosure recommended.

TPUfairPrints slowly due to bowden setup.

NylonpoorHigh temperatures needed; bed adhesion issues.

PCpoorNot recommended due to high temperature requirements.

Regularly clean the glass bed with isopropyl alcohol.

Check and tighten belts periodically to maintain print quality.

Lubricate Z-axis and other moving parts monthly.

Add a PEI sheet for better adhesion.Amazon →

Upgrade to a dual-gear extruder for improved filament handling.

Install a Raspberry Pi for OctoPrint remote monitoring.Amazon →

Large modelsPrototyping

FixMyPrint generates exact slicer settings for the Anycubic Kobra Plus - calibrated for your filament and slicer in seconds.