ANYCUBIC KOBRA GO

bowden longAuto-LevelMarlin

Buy on Amazon →Affiliate link - helps support FixMyPrint

Specifications

info

Some users report problems with initial layer adhesion.

Mitigation: Ensure the bed is clean and properly leveled. Consider using adhesive aids like glue stick or painter's tape.

PLAexcellentWorks well due to adequate cooling and easy bed adhesion.

PETGgoodMight require tuning of retraction settings.

ABSfairChallenging without an enclosure; risk of warping.

ASAfairSimilar to ABS, can warp without enclosure.

TPUgoodFlexible material can print well with slower speeds.

NylonpoorHigh temperature and enclosure needs can limit successful prints.

PCpoorRequires high heat and enclosure to avoid warping.

Regularly clean the print bed to maintain adhesion.

Calibrate the bed leveling system periodically.

Check and tighten belts and screws to ensure stability.

Upgrade to a direct drive extruder for better TPU handling.Amazon →

Install a flexible steel sheet for easier print removal.

Add stepper dampers to reduce noise.

Entry-level hobbyist projectsPrototyping with PLA

FixMyPrint generates exact slicer settings for the Anycubic Kobra Go - calibrated for your filament and slicer in seconds.