All Printers

ANYCUBIC KOBRA 2 MAX

Direct DriveAuto-LevelMarlin
Buy on Amazon →Affiliate link - helps support FixMyPrint

Specifications

Anycubic Kobra 2 Max technical specifications
Build Volume420x420x500
Bed TypePEI Spring Steel
Max Nozzle Temp260°C
Max Bed Temp90°C
Hotend TypePTFE-lined
CoolingDual Fan Cooling
Max Speed180 mm/s
Max AccelerationN/A
Motion Systembedslinger
FirmwareMarlin
Nozzle Sizes0.4mm

Known Issues

warning

bed adhesion

Issues with prints not sticking to the glass bed.

Mitigation: Use a glue stick or hairspray to improve adhesion.

See the full fix guide →

Filament Compatibility

PLAexcellentEasy to print, even at high speeds.
PETGgoodRequires tuning for consistent results.
ABSfairDifficult to print due to lack of enclosure.
ASAfairSimilar challenges as ABS.
TPUfairFlexibles can be tricky due to bowden setup.
NylonpoorNot recommended without enclosure and advanced setup.
PCpoorHigh temperature requirements make it difficult.

Maintenance Tips

Regularly clean and lubricate the Z-axis lead screws.
Check and tighten all frame bolts periodically.
Clean the nozzle and print bed after every few prints to ensure good print quality.

Popular Upgrades

Direct drive extruder conversion for better flexible printing.Amazon →
PEI spring steel sheet for improved bed adhesion and easy print removal.
Upgraded cooling fans for better print details and higher overhang capability.

Best For

Large scale modelsPrototyping with PLA.

DIALED-IN SETTINGS

FixMyPrint generates exact slicer settings for the Anycubic Kobra 2 Max - calibrated for your filament and slicer in seconds.

Generate Settings for This Printer