ANYCUBIC I3 MEGA S

BowdenMarlin

Buy on Amazon →Affiliate link - helps support FixMyPrint

Specifications

warning

Users report difficulty in maintaining a consistent level across the bed.

Mitigation: Regularly check and manually adjust the bed leveling screws.

info

Some units experience wobbling in the Z-axis leading to artifacts in prints.

Mitigation: Check and tighten all frame screws, and ensure the Z-axis rods are securely mounted.

PLAexcellentVery reliable, recommended for most prints.

PETGgoodRequires fine-tuning of temperature settings.

ABSfairCan warp without enclosure; difficult to print larger parts.

ASAfairSimilar issues to ABS with warping and adhesion.

TPUgoodCan print flexible materials but slow down the feed rate.

NylonpoorHigh-temperature requirement and warping make it difficult.

PCpoorGenerally not suitable due to high temperature demands.

Regularly clean and lubricate the Z-axis rods.

Check for wear on the PTFE tube and replace if necessary.

Keep the print surface free of debris and contaminants.

BLTouch for auto bed leveling

All-metal hotend for higher temperature materials

Improved cooling shroud for better layer cooling

Entry-level hobbyistsPrototyping with PLA and PETG

FixMyPrint generates exact slicer settings for the Anycubic i3 Mega S - calibrated for your filament and slicer in seconds.