ANKERMAKE M5C

Direct DriveAuto-LevelProprietary

Specifications

AnkerMake M5C technical specifications
Build Volume	220x220x250
Bed Type	PEI Spring Steel
Max Nozzle Temp	300°C
Max Bed Temp	100°C
Hotend Type	All-Metal
Cooling	Dual Part Cooling Fans
Max Speed	250 mm/s
Max Acceleration	5000 mm/s²
Motion System	bedslinger
Firmware	Proprietary
Nozzle Sizes	0.4mm

The FixMyPrint specifications database identifies the AnkerMake M5C's stock firmware as proprietary rather than Klipper. See the pressure advance calibration guide for Klipper, Marlin, and Bambu-specific tuning steps.

Known Issues

info

Noisy operation

The printer can be relatively noisy during operation.

Mitigation: Consider placing the printer on a vibration dampening mat or in a separate room if noise is a concern.

Filament Compatibility

PLAexcellentProduces high-quality prints with minimal effort.

PETGgoodRequires tweaking settings for optimal results.

ABSfairLack of enclosure may lead to warping.

ASAfairSimilar to ABS, enclosure recommended for best results.

TPUgoodDirect drive extruder handles flexible filaments well.

NylonpoorHigh moisture absorption can be problematic without enclosure.

PCpoorRequires high temperatures and controlled environment.

Maintenance Tips

Regularly clean and lubricate the rails and lead screws.

Check and tighten any loose screws or belts.

Perform routine calibrations for consistent print quality.

Popular Upgrades

Enhanced cooling fans for better temperature management.

Upgraded stepper motor drivers for quieter operation.

Upgraded extruder for better filament handling.

Best For

Prototype productionHobbyist use

DIALED-IN SETTINGS

FixMyPrint generates exact slicer settings for the AnkerMake M5C - calibrated for your filament and slicer in seconds.

Generate Settings for This Printer