All Guides

FIRST LAYER NOT STICKING ON BAMBU LAB P1S WITH PETG- COMMUNITY FIXES

Bambu Lab P1S PETGFirst Layer Not Sticking

22 posts in our dataset matching Bambu Lab P1S + PETG + first layer not sticking.

We pulled the 22 matching cases from r/FixMyPrint and ranked the fixes by how often they were OP-confirmed or top-voted. Use these as a starting point - the deterministic engine on Fix My Print can adjust your specific slicer settings.

TOP CONFIRMED FIXES

Confirmed on Bambu Lab P1S with PETG

  1. #1

    Adjust Z-offset

    Confirmed by 2 usersSuggested in 15 posts14% success rate
  2. #2

    Clean the build plate

    Confirmed by 1 userSuggested in 21 posts9% success rate
  3. #3

    Reduce print speed

    Suggested in 8 posts
  4. #4

    Increase bed temperature

    Suggested in 6 posts
  5. #5

    Perform a cold pull

    Suggested in 2 posts

Full Failure Guide

Want the full breakdown of first layer not sticking - what causes it, how to diagnose it on the bed, and the fixes by cause? Read the failure guide.

Read the First Layer Not Sticking guide

Printer Profile

Full specs, filament compatibility ratings, and the known quirks of the Bambu Lab P1S - including which materials it handles well and where it tends to struggle.

View the Bambu Lab P1S profile

FIX YOUR BAMBU LAB P1S NOW

Run a personalized diagnosis. The engine knows your printer's limits and PETG's working range, and returns exact slicer adjustments instead of generic advice.

Run a personalized diagnosis